All your i-cut files need to be created using Illustrator or CorelDraw.
A 1/4 point stroke needs to be placed around the area that needs to be cut.
When configuring the cut layer try to use as few nodes as possible. 1/4 inch dots with a fill, no stroke, need to be placed next to the cut stroke on a different layer about 12 inches apart (less for easy cuts and more for complex cuts.)
If a number of prints are to be made then they need to be placed on a page either 4´x4´ or 4´x8´.
If a large number of square or rectangular prints are to be made then different layers for horizontal and vertical cuts need to be configured. The I-Cut system can knife cut or router. Keep in mind that the router bit leaves 1/8 inch radius on inside cuts. On knife cuts try to keep from making sharp turns on prints that get mounted to gator board.
Please see your Design Image rep for the sizes and types of material that can be cut.
1/4 point stroke no fill
1/4 inch dots fill no stroke, use contrasting colors, black dots on white, or white dots on black.
Cut, score, dots and images should be on different layers.
Final cut file:
Map 9512 Chesapeake Dr. #402 • San
Diego, CA
92123 Ph:(858)576-3600 eFax:(858)430-2487
